应用大孔吸附树脂从农药废水中回收毕克草

毕克草为一种新型除草剂,通常情况下很难被降解,本文利用物理吸附原理通过自行制备的大孔吸附树脂从农药水中对其进行了回收,回收效果良好,同时也达到了废水处理的目的。优化的最佳实验条件:室温下,pH=1.0以及流速为5BV/h时,对COD为15000mg/L的毕克草废水吸附处理后,其出水可达《污水综合排放标准》(GB89—1996)中的一级排放标准;洗脱再生时,室温下,用95%的乙醇洗脱,流速为2BV/h,(即2倍树脂床体积/h)回收率可达98.4%,纯度达93.7%,总流程一次可处理该废水240mL。     

Optimization of the process variables for the synthesis of cardanol-based novolac-type phenolic resin using response surface methodology

Models capable of predicting the maximum extent of conversion (p) of cardanol-based novolac-type phenolic resin, have been developed using response surface methodology to determine the optimum reaction conditions. Three-dimensional response surface and their contour plot were drawn. The maximum extent of conversion (98.93%) was predicted when the cardanol was condensed with formaldehyde (molar ratio 1:0.652) at 119.84 °C for a time period of 3 h with the catalyst (e.g., citric acid) concentration of 1.988% of total volume of cardanol and formaldehyde. The pH of the reaction mixture was maintained at 3.0. These predicted values for optimum process conditions were in good agreement with experimental data.     

THE SEPARATION,PURIFICATION AND DECOLORIZATION OF NEW ANTIBIOTICS-MILUPEINAN USING ADSORPTION RESIN

1. INTRODUCTION Fig.1 The Chemical Structure of Milupeinan As a new type of antibiotics Milupeinan, not only possesses antibacterial activities against a wide range of Gram-positive and Gram-negative bacteria, but also higgh stability under th…     

橡胶增韧环氧树脂机理的研究

本文研究了固化剂种类、环氧基体平均网链长度和分散相与基体间键合情况对体系韧性等的影响.结果说明,基体平均网链长度是一个更为重要的影响因素.分散相与基体间的化学键合也是重要的.文中对橡胶增韧环氧树脂的机理提出了见解.在交联密度较低的材料中,在橡胶颗粒附近叠加的应力场诱发下发生纵深度较大的断裂过程.分散相与基体间的化学键合增大该应力场强度有利于加大断裂过程区.     

脲醛树脂合成反应过程的FTIR研究

利用傅里叶变换红外(FTIR)光谱研究了脲醛树脂合成中不同结构形成和变化情况. 对FTIR谱图解析和分析的结果表明, 在脲醛树脂预聚物合成过程中, 随着甲醛与尿素反应的进行, 红外谱图特征峰发生有规律的变化, 酰胺II带特征峰波数逐渐低移, 有更多羟甲基、醚键和—NHCH2—结构基元形成, 固化反应使上述结构基元相应减少. 着重分析了不同甲醛与尿素摩尔比(nF/nU)下尿素与甲醛反应产物结构的变化, 随nF/nU的增加, 酰胺II带特征峰波数逐渐低移, 碱性条件下醚键和—NHCH2—结构基元明显增加, 在较强酸性条件下Uron环、亚甲基桥和羟甲基显著增加, 而—NHCH2—结构基元含量下降.     

6AZO-CONTAINING SELF-ASSEMBLY ULTRA-THIN FILMS AND THEIR PHOTOVOLTAIC PROPERTIES

A kind of azo-containing resin (Azo-R) was synthesized by a simple way through the coupling reaction of 2-nitro-N-methyldiphenylamine-4-diazoresin (NDR) with phenol, and a new covalentely attached multilayer film from Azo-R as H-donor and photosensitive diazoresin, diphenylamine-4-diazoresin (DR) as H-acceptor via H-bonding attraction by selfassembly technique has been fabricated. Following the decomposition of diazonium group of DR under exposure to UV light, the H-bonds between the layers of the film convert to covalent bonds and the film becomes very stable toward polar solvents or electrolyte aqueous solutions. Thus the UV-irradiated azo-containing films can be used to measure photocurrent in a conventional three-electrode photoelectrochemical cell using KCl as supporting electrolyte. It was confirmed that the azo-containing multilayer film is responsible for the photocurrent generation.     

仲碳伯胺萃淋树脂吸萃金的性能及机理

研究了仲碳伯胺（Ｎ１９２３）萃淋树脂吸萃金的机理，溶液酸效应、吸附等温线、吸附速率、盐析剂效应及柱操作条件的影响等，将该树脂用于矿样中金含量的测定，结果与７１７＾＃离子交换树脂吸附法一致，取得了较好的结果。     

松香改性酚醛环氧树脂的合成与表征

以松香,环氧氯丙烷,甲醛及苯酚等为主要原料,合成了一种新型的环氧树脂。通过正交实验法确定了环氧化反应的最佳实验条件,即环氧化温度90℃,碱用量13 g,催化剂为cat 1,其最佳用量为0.018 mol,环氧氯丙烷的用量为50 g,碱浓度为30%(以上数值均以松香用量为70 g时计)。在最佳实验条件下合成得到了松香改性酚醛环氧树脂(简称RAPE),并用HPLC、FT-IR、NMR对其进行结构表征。结果表明,得到的RAPE其环氧值为0.28 mol/100g,平均聚合度约为3.4,酚羟基和树脂酸上的羧基基本反应完全,得到一种新型的缩水甘油醚型和缩水甘油酯型的环氧树脂。     

环氧丙烯酸酯的紫外光固化

制备了适于配制紫外光固化涂料的环氧丙烯酸酯，研究了反应温度、阻聚剂、催化剂等因素对环氧树脂与丙烯酸反应的影响；讨论了反应机理和动力学；并利用红外光谱观察了产物的紫外光固化行为。季铵盐能有效地催化环氧树脂和丙烯酸的反应，当其用量为０．６％～１．２％时，在９０～１１０℃反应４．５～８小时后，环氧基转化率大于９７％。由此配制的光固化涂料经紫外光辐照能快速固化。